This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
setting_up_the_atlas_software [2016/02/10 23:41] nimas created |
setting_up_the_atlas_software [2016/02/11 00:08] (current) nimas |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| Now you must switch to a "bash" shell by typing ''bash'' where the two lines above will be applied automatically. At this point to setup the ATLAS software you must type ''setupATLAS''. | Now you must switch to a "bash" shell by typing ''bash'' where the two lines above will be applied automatically. At this point to setup the ATLAS software you must type ''setupATLAS''. | ||
| + | ---- | ||
| ==== Atlas software and RootCore ==== | ==== Atlas software and RootCore ==== | ||
| To really set up the software following steps are required once you open a bash shell (see above): | To really set up the software following steps are required once you open a bash shell (see above): | ||
| Line 17: | Line 17: | ||
| Base,2.3.38'' | Base,2.3.38'' | ||
| - Now you can try to create a new package for ATLAS analysis like this: ''rc make_skeleton UserPackage'' | - Now you can try to create a new package for ATLAS analysis like this: ''rc make_skeleton UserPackage'' | ||
| + | where __userPackage__ is a package name which you can be anything like JohnsPackage. | ||
| + | |||
| + | Now you can see four files and folder in analysis_1 directory namely: | ||
| + | * UserPackage | ||
| + | * RooTCoreBin | ||
| + | * rcSetup.csh | ||
| + | * rcSetup.sh | ||
| + | |||
| + | ---- | ||
| - | UserPackage is a package name which you can be anything like JohnsPackage. | ||
| - | | ||
| Next time to setup the area created follow the steps below: | Next time to setup the area created follow the steps below: | ||
| - | | + | - go to "analysis_1" directory |
| - | - Go to the "analysis_1" directory | + | - type ''setupATLAS'' |
| - | - type setupATLAS | + | - type ''rcSetup'' |
| - | - type rcSetup | + | |