This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
setting_up_the_atlas_software [2016/02/10 23:51] nimas |
setting_up_the_atlas_software [2016/02/11 00:08] (current) nimas |
||
---|---|---|---|
Line 7: | Line 7: | ||
Now you must switch to a "bash" shell by typing ''bash'' where the two lines above will be applied automatically. At this point to setup the ATLAS software you must type ''setupATLAS''. | Now you must switch to a "bash" shell by typing ''bash'' where the two lines above will be applied automatically. At this point to setup the ATLAS software you must type ''setupATLAS''. | ||
+ | ---- | ||
==== Atlas software and RootCore ==== | ==== Atlas software and RootCore ==== | ||
To really set up the software following steps are required once you open a bash shell (see above): | To really set up the software following steps are required once you open a bash shell (see above): | ||
Line 17: | Line 17: | ||
Base,2.3.38'' | Base,2.3.38'' | ||
- Now you can try to create a new package for ATLAS analysis like this: ''rc make_skeleton UserPackage'' | - Now you can try to create a new package for ATLAS analysis like this: ''rc make_skeleton UserPackage'' | ||
+ | where __userPackage__ is a package name which you can be anything like JohnsPackage. | ||
+ | |||
+ | Now you can see four files and folder in analysis_1 directory namely: | ||
+ | * UserPackage | ||
+ | * RooTCoreBin | ||
+ | * rcSetup.csh | ||
+ | * rcSetup.sh | ||
- | UserPackage is a package name which you can be anything like JohnsPackage. | ||
---- | ---- | ||
+ | |||
Next time to setup the area created follow the steps below: | Next time to setup the area created follow the steps below: | ||
- go to "analysis_1" directory | - go to "analysis_1" directory | ||
- type ''setupATLAS'' | - type ''setupATLAS'' | ||
- type ''rcSetup'' | - type ''rcSetup'' | ||
- |